数控机床拜康神

January 7, 2009 11:04 pm UTC | In Misc

kxnorz机床 G-Code 转换成图片如右图所示(EPS),深度 2 毫米。

图样取自这里这里

工序 14 步,大概 5 分钟完成(机床太破……)。样品见下:

kxn_orz

Tags: ,

7 Comments »

RSS feed for comments on this post.

  1. Orz 拜康神,拜A core

    Comment by paranoia — January 8, 2009 12:13 am UTC #

  2. Orz Acore,拜康神。

    Comment by bascacaler — January 8, 2009 12:42 am UTC #

  3. 拜神要低头 动作不标准 呵

    Comment by tvoily — January 17, 2009 3:23 am UTC #

  4. 觉得这个图有点猥琐的说

    Comment by hjju — January 23, 2009 11:23 am UTC #

  5. Ha,原来是这么来的,再谢过atppp了!

    Comment by Magicglaive — February 4, 2009 9:56 pm UTC #

  6. 顺路问 facebook那个是真人照片?

    Comment by freelancer — June 12, 2009 4:34 am UTC #

  7. @freelancer: 是的。。。

    Comment by atppp — June 20, 2009 11:16 am UTC #

Leave a comment

XHTML: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <strike> <strong>

This weblog is licensed under a Creative Commons License.
Powered by WordPress. Theme based on Pool by Borja Fernandez.